Jiabaida BMS
JBD Normal bms 13S 14S 48V 30A 40A 50A 60A Lithium Battery PCB with Passive Balance NTC Temper Sensor
Couldn't load pickup availability
ZP15S002 Normal bms
- Model Number: ZP15S002
- Place of Origin: Guangdong, China
- Brand Name: JBD
- Board Thickness: 12-20MM
- Product name: 14s bms 48v 50a
- Size: 120*60*12MM
- Application: Electric Products
- Over discharge protection: yes
- Same port: yes
- Balance: Available
- Charge Protection Function: yes
- Current: 30A 40A 50A 60A
- Usage: Li Ion Lipo Battery Pack
- Voltage: 48v
Packaging & Delivery
- Selling Units: Single item
- Single package size: 23X13X16 cm
- Single gross weight: 1.000 kg
- Package Type: Manufactuers will upgrade the packaging sometimes,please refer to the actual object received.
- Package Content : 1* BMS *Balance wires
-
Model :JBD-ZP15S002 Size:120*60*12mm Current :30a 40a 50a 60a Voltage:48v String : 13s~15s Application :Electronic products Hardware discharge over - current, short - circuit protection function processing Temperature protection function Very low static consumption current Balance function :yes Drop protection function NTC function : yes
Protection function description
Overcharge protection: When the battery is under the charging state, the voltage keeps going up. When the protection board detects that the voltage of any cell is higher than the overcharge protection value, the protection board will start timing immediately. When the time reaches the overcharge protection delay, the protection board will turn off the charging MOS tube, at that time, it cannot be charged.
Overcharge protection recovery: After the overvoltage protection appears on the protection board, the battery voltage will going down under the static or discharge state of the battery. When the protection board detects that each voltage is lower than the recovery voltage of the overcharge protection, the protection board will output a signal and turn on the charging MOS tube to charge.
Over-discharge protection: When the battery is under the discharge state, the voltage keeps going down. When the protection board detects that the voltage of any cell is lower than the overcharge protection value, the protection board will start timing immediately. When the time reaches the over discharge protection delay, the output signal of the protection board will turn off the discharge MOS tube, the load lock circuit will work, but, it cannot discharge at this time.
Over discharge protection recovery: After the over discharge protection appears on the protection board, the battery voltage will going up under the static or discharge state of the battery. When the protection board detects that each voltage is higher than the recovery voltage of the over discharge protection. At this time, disconnect the load or charge, the protection board will output a signal and turn on the charging MOS tube to charge.
Overcurrent protection: When the battery is under the static or discharge state, the current suddenly increases. When the protection board detects that the current reaches the overcurrent protection value, the protection board will start timing at that time. When the current duration in the circuit reaches the overcurrent protection delay time, the output signal of the protection board will turn off the discharge MOS tube, and the load lock circuit will work. At this time, the discharge cannot be conducted.
Overcurrent protection recovery: After the discharge overcurrent protection appears on the protection board, the discharge MOS tube is turned off, and the current in the loop becomes 0. At this time, the load is disconnected or charged, the output signal of the protection board will turn on the discharge MOS tube to discharge.
When assembling the wiring, weld the cable and the cell correctly, connect the B- of the PCM with the total negative pole of the cell, and then insert the cable into the needle base on the PCM. (Note: different connection modes for different strings, and different connection modes for the same port)
1
